====== Протокол загрузки Linux ====== RomBOOT >Start AT91Bootstrap... Copy application ... Run ... U-Boot 1.1.5 (Apr 29 2008 - 20:23:52) DRAM: 64 MB NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0xda ( NAND 256MiB 3,3V 8-bit) NAND: Pagesize: 2048, Blocksize: 128K, OOBsize: 64 256 MiB DataFlash:AT45DB321 Nb pages: 8192 Page Size: 528 Size= 4325376 bytes Logical address: 0xC0000000 Area 0: C0000000 to C0003FFF (RO) Area 1: C0004000 to C0007FFF Area 2: C0008000 to C0037FFF (RO) Area 3: C0038000 to C041FFFF *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial KS8721 PHY Detected No link MAC: error during RMII initialization Hit any key to stop autoboot: 0 ## Booting image at 20400000 ... Image Name: Linux Kernel Image Image Type: ARM Linux Kernel Image (gzip compressed) Data Size: 1422821 Bytes = 1.4 MB Load Address: 20008000 Entry Point: 20008000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Starting kernel ... Linux version 2.6.24 (root@armmaker) (gcc version 4.2.0 20070413 (prerelease) (CodeSourcery Sourcery G++ Lite 2007q1-10)) #91 Sat May 17 02:50:14 MSD 2008 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 Machine: StarterKit.ru SK-AT91SAM9XE512-S3E Memory policy: ECC disabled, Data cache writeback Clocks: CPU 200 MHz, master 100 MHz, main 12.000 MHz CPU0: D VIVT write-back cache CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 Kernel command line: root=/dev/ram0 rw initrd=0x23100000,0x500000 console=ttyS0,115200 mem=64M AT91: 96 gpio irqs in 3 banks PID hash table entries: 256 (order: 8, 1024 bytes) Console: colour dummy device 80x30 console [ttyS0] enabled Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 64MB = 64MB total Memory: 56832KB available (2612K code, 230K data, 116K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok net_namespace: 64 bytes NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 Time: pit clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 5120K NetWinder Floating Point Emulator V0.97 (double precision) JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. yaffs Apr 22 2008 10:39:18 Installing. io scheduler noop registered (default) atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL atmel_usart.2: ttyS2 at MMIO 0xfffb8000 (irq = 8) is a ATMEL_SERIAL RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize loop: module loaded ssc ssc.0: Atmel SSC device at 0xc4870000 (irq 14) MACB_mii_bus: probed eth0: Atmel MACB at 0xfffc4000 irq 21 (00:00:00:00:00:00) eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffffff:01, irq=-1) Driver 'sd' needs updating - please use bus_type methods NFTL driver: nftlcore.c $Revision: 1.98 $, nftlmount.c $Revision: 1.41 $ NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit) AT91 NAND: 8-bit, ECC Scanning device for bad blocks Creating 2 MTD partitions on "at91_nand": 0x00000000-0x00800000 : "Partition 1" 0x00800000-0x10000000 : "Partition 2" atmel_spi atmel_spi.0: Atmel SPI Controller at 0xfffc8000 (irq 12) mtd_dataflash spi0.0: AT45DB321x (4224 KBytes) usbmon: debugfs is not available at91_ohci at91_ohci: AT91 OHCI at91_ohci at91_ohci: new USB bus registered, assigned bus number 1 at91_ohci at91_ohci: irq 20, io mem 0x00500000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. udc: at91_udc version 3 May 2006 mice: PS/2 mouse device common for all mice i2c /dev entries driver usbcore: registered new interface driver usbhid drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 RPC: Registered udp transport module. RPC: Registered tcp transport module. RAMDISK: Compressed image found at block 0 EXT2-fs warning: maximal mount count reached, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). Freeing init memory: 116K Starting system... mount: Mounting none on /dev/pts failed: No such file or directory SIOCSIFFLAGS: Invalid argument SIOCSIFFLAGS: Invalid argument chgrp: unknown group name: utmp yaffs: dev is 32505857 name is "mtdblock1" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.1, "mtdblock1" yaffs: auto selecting yaffs2 yaffs: restored from checkpoint umount: Couldn't umount /mnt/mmc: Invalid argument rmmod: at91_mci: No such file or directory mount: Mounting /dev/mmc1 on /mnt/mmc failed: No such device or address mount: Mounting /dev/sda1 on /mnt/usb failed: No such device or Please press Enter to activate this console. BusyBox v1.1.2 (2008.04.21-23:55+0000) Built-in shell (ash) Enter 'help' for a list of built-in commands. [@SK-AT91SAM9 /]$mount /dev/root on / type ext2 (rw) none on /dev/shm type tmpfs (rw) /proc on /proc type proc (rw) /dev/mtdblock1 on /mnt/nand type yaffs (rw,sync) [@SK-AT91SAM9 /]$df Filesystem 1k-blocks Used Available Use% Mounted on /dev/ram0 3963 3380 583 85% / none 31040 0 31040 0% /dev/shm /dev/mtdblock1 253952 1152 252800 0% /mnt/nand [@SK-AT91SAM9 /]$ps aux PID Uid VmSize Stat Command 1 0 336 S init 2 0 SW< [kthreadd] 3 0 SW< [ksoftirqd/0] 4 0 SW< [watchdog/0] 5 0 SW< [events/0] 6 0 SW< [khelper] 47 0 SW< [kblockd/0] 60 0 SW< [khubd] 65 0 SW< [kmmcd] 86 0 SW [pdflush] 87 0 SW [pdflush] 88 0 SW< [kswapd0] 89 0 SW< [aio/0] 232 0 SW< [mtdblockd] 233 0 SW< [nftld] 265 0 SW< [rpciod/0] 283 0 84 S /bin/telnetd -l /bin/ash 285 0 96 S /bin/httpd -h /mnt/www 301 0 444 S -ash 307 0 372 R ps aux [@SK-AT91SAM9 /]$